Rule Controllers are independent of each other. If there are multiple Rule Controllers defined for a extraction or loader set, each Rule Controller can be configured to connect to the same Oracle schema or entirely different ones.

The DataBee software is multi-threaded and can run up to eight rules in parallel. It is common to have a situation in which certain rules cannot run simultaneously and must run sequentially one after the other as a chain. The execution order of the extraction or loader rules is controlled through the use of rule blocks. Please see the discussion of Rule Blocks in the extraction and loader set help pages to understand how to explicitly control the execution order of the extraction and loader rules. Note that Rule Controllers themselves can have a designated rule block. A Rule Controller (and hence its dependent masking rules) with a lower rule block will always execute before a Rule Controller with a higher rule block.

A Rule Controller is automatically created when a new extraction and loader set is built using the New Set wizard. Additional Rule Controllers can be created by launching the New Rule Controller form using the New Rule button located on the bottom right of the main Set Designer form.

How to Create a New Command Rule